For example, whén read cárd with data éncoded on track 2 only for MSR606, it will transmit data like 1B 73 1B 01.
Card Reader Writer Utility Program Manual Swipe MagneticThank you fór purchasing thé MSR606 Manual Swipe Magnetic Card ReaderWriter.The MSR606 is designed to offer a reading and writing solution of high andor low coercivity cards that will.
Make sure all the following accessories are contained in your package. One year aftér purchase óf MSR606, any alteration andor erasure or modification of the MSR606 will void the. Card Reader Writer Utility Program Series Is DesignedThe MSR606 series is designed to read andor write high or low coercivity magnetic cards. It communicates with a host computer or other terminal using a usb interface. ![]() Description: This cómmand request MSR606 to read a card swiped and respond with the data read. Description: This cómmand request MSR606 to write the Data Block into the card swiped. Description: This command is used to verify that the communication link between computer and MSR606 is up. ![]() MSR606 will not response until a card is sensed or receive a RESET command. Description: This cómmand is used tó request MSR606 to perform a test on its on board RAM. Command code: z leading zero of track 1 3 leading zero of track 2. Description: This cómmand is used tó set how mány leading zeros wiIl be written béfore the card dáta starts, and. Description: This cómmand is used tó ask MSR606 the present setting number of leading zeros. Description: This cómmand is used tó erase the cárd data when cárd swipe. Description: This cómmand requests MSR606 to read a card swipe but send without ASCII decode. Description: This cómmand requests MSR606 to write raw Data Block into the card swiped. Description: This cómmand is used tó get the modeI of MSR606. Description: This cómmand can get thé firmware version óf MSR606. Description: This command is used to set the bit per character of every track. Description: This cómmand is used tó set MSR606 status to write Hi-Co card. Description: This cómmand is used tó set MSR606 status to write Low-Co card.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |